(02) 9790-8733

[qode_elements_holder number_of_columns=”one_column”][qode_elements_holder_item advanced_animations=”no” item_padding=”100px 0 40px 0″]

Flat Bottom Grease Arrestors

Flat Bottom Grease Arrestors are commonly used in Butcher’s shops, Cafe’s, Restaurants, Bakeries, Take-aways etc. to remove the free grease and oils and assist in preventing pipe blockages etc. They are required by legislation in many areas.
[/qode_elements_holder_item][/qode_elements_holder]
[qode_elements_holder number_of_columns=”one_column”][qode_elements_holder_item advanced_animations=”no” item_padding=”0 0 80px 0″]

Why fibreglass and not concrete?

As per Sydney Water requirements, all concrete / reinforced precast grease arrestors must be epoxy coated internally, annually.

Fibreglass Grease Arrestors are fabricated with a 7mm Iso-resin wall, HPR-800 Gun Rovings, Iso-Npg Gelcoat internal lining and Iso-Npg Flowcoat external finish.

Aglass Grease Arrestors do comply with the principals of the following Australian Standards.

  1. AS 5200 – 2005 – Procedures for certification of plumbing and drainage products.
  2. AS 3500:2003 – Plumbing and Drainage.
  3. AS/NZ 4494:1998 – Discharge of commercial and industrial liquid waste to sewer – General performance requirements.

Sizes: Start at 1000 litre and up to and including 5000 litres

Construction: Heavy Duty Fibreglass

Installation: Can be installed above ground and below ground

A wide range of lids are available including:

  1. Heavy Duty Fibreglass for garden beds.
  2. Light Duty Class B – Pedestrian trafficable gas tight.
  3. Heavy Duty Class D – Cars, Trucks, Semi Trailers and Forklifts.

If gravity fall is not obtainable on a below ground unit various sizes of Risers are available.

[/qode_elements_holder_item][/qode_elements_holder]
[qode_elements_holder number_of_columns=”one_column”][qode_elements_holder_item advanced_animations=”no” item_padding=”0 0 100px 0″]
[/qode_elements_holder_item][/qode_elements_holder]